H 3 H 5 N10.4.2 – Pairing a radio relay BTR-101 H 5 N10.5 – Pairing a mobile phone H 1¢ P 5 N10.6 – Pairing an engine compartment H 3 H 5 N10.3.2 – Pairing a door sensor DMS-100 BT H 5 N10.3.3 – Pairing a door sensor DMS-100 BT H 5 N10.3.4 – Pairing a door sensor DMS-100 BT H 5 N10.4.1 – Pairing a radio relay BTR-101 H 1¢ P 4¢ P 1
#QUICKBOOT V2.1 UPDATE#
PROGRAMMING TABLE Function VALET button N0 – Entering a level Level Level Update N1 – Pairing a remote control D030/Watch2 P 1 H 3* N2 – Changing the Service PIN-code P 2 N3 – Recording the idle speed (rpm) P 3 N4 – Reset to the factory settings P 4 H 4 N10.1.1 – Pairing a radio tag BT760/BT770 H 1¢ P 1¢ P 1 H 3 Connect the wire 4 to the ignition (+12V when ignition is on).
#QUICKBOOT V2.1 BLUETOOTH#
* WARNING! See the “Level 10 – Manage Bluetooth devices” section. Keep minimum distance of 2 mm between the modules and metal parts WARNING! Do not shield the built-in antennas when installing the additional devices. The maximum number of paired Bluetooth devices must not exceed 14. WARNING! All additional devices included in the system set are paired with the system.
#QUICKBOOT V2.1 INSTALL#
IT IS FORBIDEN to install the temperature sensor at the place where temperature is higher than the operating range of the sensor (+125C) and cable (+80C). IT IS FORBIDEN to install the security system with damaged output cables. IT IS FORBIDEN to bypass original fuses of a security system in the installation process. IT IS FORBIDEN to install the system on a car with normal voltage other than 12V. All power circuits of additional devices that are not powered through the base unit of the system should have their own fuses.Disconnect the power supply before installing/replacing a SIM-card.Keep minimum distance of 2 mm between the modules and metal parts. Do not shield the built-in antennas when installing the system and additional devices.Before starting the installation of the system, choose a car model in the ALARM STUDIO (CAN-bus protocol).